Builds
Old Posts
- July 2020
- June 2020
- May 2020
- April 2020
- October 2016
- September 2016
- August 2016
- July 2016
- June 2016
- March 2015
- December 2014
- November 2013
- October 2013
- July 2013
- June 2013
- May 2013
- April 2013
- March 2013
- November 2012
- October 2012
- June 2012
- May 2012
- April 2012
- March 2012
- October 2011
- September 2011
- July 2011
- May 2011
- October 2010
- September 2010
- July 2010
- June 2010
- May 2010
- April 2010
- March 2010
Monthly Archives: May 2011
Headstock – May 2011
Tuner holes drilled from the back, ~3/4 of the headstock deep. These are then revealed when the headstock is taken to its correct depth. With no bandsaw or planer, I used the same “saw dust maker” as used for the … Continue reading
Posted in Neck Build
Comments Off on Headstock – May 2011
Neck Outline – April 2011
(Stage 2 not shown, mark the centre line on the blank and cut the truss rod channel) Copied the MDF template first onto thicker MDF (1/2″) as there is more for the bearing to run on. Traced the outline onto … Continue reading
Posted in Neck Build
Comments Off on Neck Outline – April 2011
Neck Build – Start – April 2011
Starting on my first guitar neck (to replace the bought neck used in last years build). Make a template for the neck in 1/4″ MDF by: Drawing a centre line for the neck Marking the nut position and width Marking … Continue reading
Posted in Neck Build
Comments Off on Neck Build – Start – April 2011